Note: The remote control uses 4 5th batteries Main car battery: 7.4V 2S lithium battery (battery connector is XT60) Battery size: length 83MM wide 40MM high 16MM size (battery and power monitor need to be purchased separately)

Steps:

1. Before turning on the remote control, please check the position of each switch and the alignment lever to return to the neutral position. After confirming, the switch can be opened. 2. Turn on the remote control switch (the switch of the remote control should be in the up position), 3.Connect the main vehicle power supply and wait for the signal to be confirmed before it can be operated (about 5S).

note:

1. If the pre-operation is very likely to make the ESC enter the setting mode, the ESC will not work properly. 2. Remote control battery installation: install attention to the battery positive and negative. 3. Before the main car battery is installed: first measure the voltage, the voltage can not be lower than 7.4V.

Version without remote control (wooden rack and basket are given after sale)

Version with remote control (wooden rack and basket are given after sale)